Flake epoxy in Upland
Dense chips that hide the grit a windy day blows into an Upland garage.
Flake epoxy details

Garage floors, pool deck coatings and interior floors for Upland homes, from the foothills down to the 10.
★★★★★ 5-Star Rated · 93 reviews on Google, Facebook, Houzz & more
Free on-site estimate
Tell us about the floor and we will call you back to book a visit.
Upland epoxy flooring starts at $2,600. A two-car flake garage of up to 400 sq ft costs $2,600 to $4,000 and goes down in one day, with grinding, crack repair and a polyaspartic topcoat included. Read the details on our flake epoxy page.
Upland incorporated on May 15, 1906, after starting out as North Ontario. The city sits at about 1,242 feet on the border with Los Angeles County. For permits on additions or new slabs, check with the City of Upland.
We drive over from our base in Pomona for every Upland estimate. The visit is free: we measure, test the slab for moisture and give you a written price before any work starts.
Solid color epoxy floor, UplandAll four systems carry a limited lifetime adhesion warranty and a polyaspartic topcoat.
Dense chips that hide the grit a windy day blows into an Upland garage.
Flake epoxy detailsA smooth, bright floor for gyms and craft rooms on sound slabs.
Solid color epoxy detailsA poured, swirled look for dens and converted garages.
Metallic epoxy detailsA grippy texture for sloped garages near the foothills.
Quartz & sand finish detailsAt about 1,242 feet, Upland is fairly flat but slopes gradually upward to the north, so some driveways and garages tilt toward the street. A slope is fine for a coating, and we add texture where water runs.
Summers here run hot and dry, and a garage door left open on a windy day can coat the floor in grit. The polyaspartic topcoat we use rinses clean and resists the UV that yellows plain epoxy.
Pool decks take the most sun. Our outdoor concrete coatings use a light blend that stays cooler under bare feet, and you can pick the blend on our color chart.
Solid color epoxy floor, UplandBefore 1906 the town was North Ontario, part of the irrigation colony George Chaffey planned after he bought the land in 1882. Foothill Boulevard here follows the old route that later became Route 66.
That long history means a wide range of slab ages. We look at each one before we price it, and older floors may need more crack repair. Want a coated walkway too? A pool deck coating or a driveway coating can go down the same week.
In the 2020 census, Upland had 79,040 residents, up from 73,732 in 2010, and 54.6% of housing units were owner occupied. After World War II, land values rose and growers sold their orchards to developers, which is when much of the city filled in with homes.
Older garages often need more crack repair before the basecoat, and newer ones need a grind to open up smooth troweled concrete. Either way the floor gets the same method. If your home has a game room or office on a slab, a metallic epoxy floor is worth a look.
Full broadcast flake floors that hide dust and tire marks.
Light blends with grip for wet, sunny concrete.
Here is how a one-day flake floor runs in Upland.
The slab gets a moisture reading, and we map cracks and old sealer.
Grinding removes sealer and laitance down to hard concrete.
Flake goes into the wet tinted base until no base shows.
The UV-stable topcoat goes on, and the floor is ready to walk that night.
The table shows a typical two-car garage of up to 400 sq ft. Every Upland project starts at $2,600, and commercial floors get a written quote after a free site visit.
| System | Per sq ft | Typical two-car garage (up to 400 sq ft) | Install time |
|---|---|---|---|
| Flake epoxy | $6.50-$10 per sq ft | $2,600-$4,000 | 1 day |
| Solid color epoxy | $9.50-$11.50 per sq ft | $3,800-$4,600 | 3 days |
| Metallic epoxy | $12.50-$18.50 per sq ft | $5,000-$7,400 | 3-4 days |
| Quartz & sand finish | $9-$16.50 per sq ft | $3,600-$6,600 | 2-3 days |
| Grind and seal | $6.50-$9 per sq ft | $2,600-$3,600 | 1-2 days |
| Patio, driveway & pool deck coating | $8-$12 per sq ft | $3,200-$4,800 | 1-2 days |
| Commercial & industrial | Quoted after a free site visit | Quoted after a free site visit | Depends on size and downtime |
Prices and details reviewed November 2026.
See finished floors in our gallery.
An Upland flake garage floor of up to 400 sq ft costs $2,600 to $4,000 and takes one day. Metallic costs $5,000 to $7,400 for the same space.
No. We are based in Pomona and serve Upland as one of our nearby cities. Estimates are free and happen at your home.
Yes. We coat sloped slabs and add a textured topcoat where water runs, so the surface keeps its grip when wet.
Pool deck and patio coatings in Upland cost $8 to $12 per sq ft and take 1-2 days, with a light blend that stays cooler underfoot.
Upland owners can walk on a flake floor that evening and park on it after 24 hours. Solid color needs 3 days in total.
Yes. We coat garages and patios in every part of Upland, from the flat south side to the streets that climb toward the mountains.
Most Upland owners choose flake, since it hides dust and goes down in one day. Metallic suits dens and converted garages.
Yes. Driveway and walkway coatings cost $8 to $12 per sq ft and take 1-2 days.
We serve 91784, 91785 and 91786, which cover all of Upland.
No. We grind off old sealer and paint so the new coating bonds to bare concrete.
We measure, test the concrete for moisture and give you a written price before any work starts. Projects start at $2,600.